FNSW-2400PS

Hardware

24-Port 10/100Mbps Fast Ethernet interfaces

8K MAC Address Table size

Switch architecture with non-blocking Switch fabric (4.8Gbps) and wire-speed throughput

Prevent packet loss with backpressure (Half-Duplex) and 802.3 PAUSE frame flow control (Full-Duplex)

Auto-MDI / MDI-X on each port

PoE

Complies with IEEE 802.3af Power over Ethernet Mid-Span PSE

Up to 24 IEEE 802.3af devices powered

125 Watts PoE Power Budget

Supports PoE Power up to 15.4 Watts for each 802.3af PoE port

Auto detect powered device (PD)

Circuit protection prevents power interference between ports

Remote power feeding up to 100m

Management

Remote Web interface for Switch management and setup

Supports SNMP v1

Supports DHCP Option82 and DHCP Relay

Firmware upgrade through Web interface

Configuration backup / reload through Web interface

Reset button for system reboot or reset to factory default

Layer 2 Features

VLAN

IEEE 802.1Q Tag-based VLAN

Port-Based VLAN

MTU VLAN (Multi-Tenant Unit VLAN)

Link Aggregation

up to 2 trunk groups

up to 4 Fast Ethernet ports per trunk group

IEEE 802.3ad LACP (Link Aggregation Control Protocol)

Spanning Tree Protocol

STP, IEEE 802.1D (Classic Spanning Tree Protocol)

RSTP, IEEE 802.1w (Rapid Spanning Tree Protocol)

Loopback Detection

Port Mirroring to monitor the incoming or outgoing traffic on a particular port

QoS

2 priority queues on all switch ports

Traffic classification:

Port-Based priority

IEEE 802.1p based priority

IP TOS / DSCP based priority

TCP / UDP Port Based QoS

Strict priority and Weighted Round Robin (WRR) CoS policies

Broadcast Storm Control support

In/Out rate limit control on each port

Multicast

Supports IGMP Snooping v1 and v2

Security 

MAC address filter

TCP & UDP filter on each port

Management idle time security

Cost-Effect Managed Edge/Department PoE Switch